Our half bathroom needed some TLC. While it has served it purpose with fresh paint, I knew it could be better. I decided to use shiplap but install the boards vertically.
Materials:
1×4 Primed Pine
1×2 Primed Pine
1in x 6in x 8ft MDF shiplap boards
Wood Filler
Caulk
Paint
Tools:
Miter Saw
Nail Gun
Trim Puller
Jigsaw
Measuring Tape
Step 1:
You will want to plan out the room and decide how high you want the vertical shiplap boards to be. I decided to make the vertical shiplap 4ft high cutting the 8ft board in half and cutting my cost.
Step 2:
Remove your baseboards from your walls. Start by using a utility knife to score the caulk line which breaks the seam for easier removal. Doing this will allow you to get the trim puller and baseboard remover behind the board. If you work slowly and carefully, the trim can be reused!
Step 3:
Cut and install the 1x4 horizontal board. First cut the boards to the width of your walls and nail into the studs with your brad nailer, making sure everything is level.
Step 4:
I used 1in x 6in x 8ft MDF shiplap boards from Home depot and cut them in half to save money. Once the boards are cut, line them up along the wall butting them up up to the horizontal board and start installing. Since the shiplap boards are a tongue and groove system, you can easily lock the boards together and secure to the wall using your nail gun. To minimize the holes that need to be filled later, shoot your nails into the tongue of the board since your next board will cover those nails.
Step 5:
Reinstall your baseboard. The boards will need to be cut down a little bit. You will need to miter the corners at a 45 degree angle using your miter saw. Then use your nail gun to reinstall the baseboards to finish the walls.
Step 6:
Caulk and Fill Nail Holes. You will want to use wood filler on the boards and baseboards to fill the nail holes. While the wood filler is drying, caulk both edges of the horizontal board and the top of the baseboards. I prevent any water leaks, you will want to caulk the shiplap behind the sink. I also used a baby wipe to wipe off the excess caulk, this keeps your hands clean (er).
Step 7:
Sand and Paint. Once the wood filler is dry, you'll want to sand it down for a smooth finish to paint. I used Behr Ultra Pure White in a satin finish. If you want to use a color on the shiplap, I would recommend painting the boards prior to installing. This way you won't have to paint the seams individually.
I hope this provides you with the confidence to tackle vertical shiplap for any room in your house!
XOXO
Jillian.
Comments